Siser's EasyPSV Holographic is the wow factor you've been look for! There are six available colors with a pearlescent finish that will make all your hard goods stand out! The light tack makes for easy removability and the translucent appearance enables even more creative possibilities. Recommended for indoor use only.
Surface Prep Instructions
For best adhesion, remove any dirt, dust, grease, etc to prepare the surface you want to decorate with EasyPSV. The following cleaning method is not recommended for porous surfaces such as unfinished/untreated wood. It is recommended that all other surfaces be spot tested with care before cleaning the entire application area.
Non-porous surfaces can be cleaned with a mix of approximately 2 parts water and 1 part isopropyl alcohol (70% or higher for best results) or non-ammonia based window cleaner. Use a microfiber or lint free towel to clean the application area with the mixture. Paper towel is not recommended since it will leave behind small bits of paper that can become trapped under the EasyPSV during application. Ensure the area is completely dry before applying.
*The cleaning method outlined above is subject to modification and not always suitable for every substrate. The purchaser should independently determine with their own testing to use this method or not on a case by case basis.
Application Instructions
- Place EasyPSV with the liner side down and cut your design. (DO NOT reverse/mirror your design.)
- Weed excess vinyl.
- Remove the application tape's paper liner. Place tape on top of EasyPSV and burnish with a squeegee.
- Lift the application tape and EasyPSV away from the paper liner to expose the removable adhesive.
- Place the application tape on your desired object and burnish with a squeegee to fully adhere the design.
- Gently peel away the application tape, leaving just your EasyPSV design on the object.
Removal Instructions
Clean removability guaranteed for 2 years. Later removal may require and adhesive remover to clean all the adhesive from the surface. If the EasyPSV is stubbornly sticking, the heat from a hair dryer or garment steamer can help loosen the adhesive. However, heating is not recommended for glass due to possible shattering. To remove Permanent EasyPSV from glass, saturate the decal with soap and water. Cover with plastic wrap and let sit for a few hours before attempting to remove. An adhesive remover may still be required to clean all adhesive from the surface after removing the EasyPSV.
*The removal instructions outlined above are subject to modification and not always suitable for every substrate. The purchaser should independently determine with their own testing to use this method or not on a case by case basis.
